Jubilee CoreXY belt tensioning

Set and match the two Jubilee CoreXY belts. The 3D procedure targets about 61 Hz on the upper belt and matches the lower belt before securing the motors.

Open the procedure in 3D

Tools and parts

Tools
Hex keys that fit the motor mounting and tension adjustment screws, and a frequency tuner app.
Parts
An assembled Jubilee CoreXY frame with its upper and lower belts and both adjustable XY motor mounts.

Measure comparable belt spans with the carriage centred. The Jubilee maintenance reference calls for at least 60 Hz per belt and a difference of no more than 1 Hz.

Step by step

Follow these steps in 3D

5 steps
  1. Center the carriage

    Center the carriage in the middle of the frame by eye. The belts may skip while they are loose; this is acceptable during this adjustment.

  2. Release the drive motors for adjustment

    Ensure both drive motors are loose enough to slide back and forth in their slots when pushed by hand. Loosen their mounting screws as needed. Locate the tensioning setscrews at the motor corner plates.

  3. Tune the upper belt to approximately 61 Hz

    Work in a quiet environment. Install and run a guitar-tuning app on a smartphone; it must display frequency in Hz. Hold the microphone near the front span of the upper belt and pluck the belt like a guitar string. Measure its frequency, then gradually tighten its tensioning setscrew to increase tension. Stop when the measurements average around 61 Hz .

  4. Match the lower belt to the upper belt

    Pluck and measure the lower belt with the tuning app, with the microphone near its front span. Tighten its tensioning setscrew until its measured frequency matches the upper belt to within 1 Hz .

  5. Secure all eight XY motor screws

    When belt tensioning is complete, tighten down all eight XY motor screws.

Sources and credits

Public 3D instructions by Téa on TwinWorks Community. The numbered steps follow the public procedures linked above.

Hardware design by Joshua Vasquez and the Jubilee project. See the upstream documentation and CC BY 4.0 license.

Updated